Thursday, February 28, 2019
Wednesday, February 27, 2019
ANTI-GRAVITY PROJECT by Jeff Lucas Astrophotographer : Published on Oct 26, 2018
Some YouTube notes on Lenz's, Ohm's Law and Nikola Tesla about how Jeff Lucas thinks anti-gravity works.
Some YouTube notes on Lenz's, Ohm's Law and Nikola Tesla about how I think anti-gravity works. When it comes to building anti-gravity, everyone is building it wrong, its upside down, its not the number of magnets, it how much E = I/R ~ direct current you can apply to magnets to create levitation repulsive force, polarities e.g. North to North, South to South.
We're not applying direct current to magnets to increase its polarity and we're not inducing spin against reflective metals. I believe if we can apply a strong surge of direct current like a rail gun power to magnets using series circuit north to south (top to bottom) and induce high spin with R/C 10K rpm motors to spin magnets and reflect / deflect the increased magnetic repulsive field from top thin plate of copper / aluminum sheet downwards, anti-gravity; it should work. If I want this to work without being tethered as seen here, I will need 1.21 gigawatts of power but, as you know this would be a larger scale Marty. I will be making a small type Hover Board scaled height 4", width 10"..
Can you connect the dots?
1:47 Its not how many magnets but how much direct current applied.
2:22 Lenz's Law in motion
3:08 Aluminum makes great sail for magnetic flux, see later in video.
4:12 Halbach Array of Magnets
4:43 Halbach Array doesn't have applied direct current, imagine if applied.
5:51 Lenz's Law explained back in 2009 by iLevitation
6:24 Gravity Wave - wrong direction - need opposing polarities.
7:46 No need for mercury unless you have 1.21 gigawatts for direct current.
9:18 Anti-Gravity demoed in house - notice aluminum plating and its pitted for reason.
10:03 Anti-Gravity demoed outside backyard -notice aluminum plating and its pitted for some reason ~ Hint: purple beetle inner wings.
10:22 Bob Lazar, "How would you describe gravity?"
For this project I will need two R/C 10K RPM drives @ 12volts, no bigger than your 9 volt battery. Next fabricate a conductive six point star hub to hold six neodymium 115 lbs lifting magnets, rare Earth magnets staggered North, South, North, South, North, South, radius x/y axis of each arm magnet will be 2 inches away from center hub for 4 inch diameter rotation to create repulsive force upwards and outwards lift beneath 5 to 7 inch copper array..
Create mounts for two 10K RPM drives with copper shaft to spin six star magnet hub. First 10K drive will sit below stationary copper array, 2nd 10K RPM drive is for top rotating copper disk, to counter rotate bottom rotating magnets for stability, negating yaw. The 2nd rotating copper disk may contribute to increasing magnetic repulsion. Rotating disk and stationary will have a few holes so electrons can pass upwards, the spacing of the copper plating may result in a Biefeld-Brown Effect, my goals is to energize the magnetic fields, not move ionized air, however it may so. Copper shaft will conduct DC power like a trolley electric car or like your electric train set, Powered by direct current, 7:46 positive lead will be connected to top shaft, negative terminal to bottom shaft to complete series circuit. DC voltage will be used to energize, increase magnetic field.
Next, I will carefully fabricate a flat pitted reflective magnetic flux array, from 99.9% pure copper cut metal sheet foil 0.1X7.9X19.7" cut into a circle, center hole punched for 10K rpm drive shaft for six magnet hub. The pitted copper array positioned 0.5 to 1 inch (varying magnetic field) above the rotating magnets polarities North South etc. for optimized repulsive force, you want it spaced where the magnetic field attracts to the copper array at its strongest point.
Next phase testing Halbach array 5:47 configuration for rotation.
Category
Science & Technology
Some YouTube notes on Lenz's, Ohm's Law and Nikola Tesla about how I think anti-gravity works. When it comes to building anti-gravity, everyone is building it wrong, its upside down, its not the number of magnets, it how much E = I/R ~ direct current you can apply to magnets to create levitation repulsive force, polarities e.g. North to North, South to South.
We're not applying direct current to magnets to increase its polarity and we're not inducing spin against reflective metals. I believe if we can apply a strong surge of direct current like a rail gun power to magnets using series circuit north to south (top to bottom) and induce high spin with R/C 10K rpm motors to spin magnets and reflect / deflect the increased magnetic repulsive field from top thin plate of copper / aluminum sheet downwards, anti-gravity; it should work. If I want this to work without being tethered as seen here, I will need 1.21 gigawatts of power but, as you know this would be a larger scale Marty. I will be making a small type Hover Board scaled height 4", width 10"..
Can you connect the dots?
1:47 Its not how many magnets but how much direct current applied.
2:22 Lenz's Law in motion
3:08 Aluminum makes great sail for magnetic flux, see later in video.
4:12 Halbach Array of Magnets
4:43 Halbach Array doesn't have applied direct current, imagine if applied.
5:51 Lenz's Law explained back in 2009 by iLevitation
6:24 Gravity Wave - wrong direction - need opposing polarities.
7:46 No need for mercury unless you have 1.21 gigawatts for direct current.
9:18 Anti-Gravity demoed in house - notice aluminum plating and its pitted for reason.
10:03 Anti-Gravity demoed outside backyard -notice aluminum plating and its pitted for some reason ~ Hint: purple beetle inner wings.
10:22 Bob Lazar, "How would you describe gravity?"
For this project I will need two R/C 10K RPM drives @ 12volts, no bigger than your 9 volt battery. Next fabricate a conductive six point star hub to hold six neodymium 115 lbs lifting magnets, rare Earth magnets staggered North, South, North, South, North, South, radius x/y axis of each arm magnet will be 2 inches away from center hub for 4 inch diameter rotation to create repulsive force upwards and outwards lift beneath 5 to 7 inch copper array..
Create mounts for two 10K RPM drives with copper shaft to spin six star magnet hub. First 10K drive will sit below stationary copper array, 2nd 10K RPM drive is for top rotating copper disk, to counter rotate bottom rotating magnets for stability, negating yaw. The 2nd rotating copper disk may contribute to increasing magnetic repulsion. Rotating disk and stationary will have a few holes so electrons can pass upwards, the spacing of the copper plating may result in a Biefeld-Brown Effect, my goals is to energize the magnetic fields, not move ionized air, however it may so. Copper shaft will conduct DC power like a trolley electric car or like your electric train set, Powered by direct current, 7:46 positive lead will be connected to top shaft, negative terminal to bottom shaft to complete series circuit. DC voltage will be used to energize, increase magnetic field.
Next, I will carefully fabricate a flat pitted reflective magnetic flux array, from 99.9% pure copper cut metal sheet foil 0.1X7.9X19.7" cut into a circle, center hole punched for 10K rpm drive shaft for six magnet hub. The pitted copper array positioned 0.5 to 1 inch (varying magnetic field) above the rotating magnets polarities North South etc. for optimized repulsive force, you want it spaced where the magnetic field attracts to the copper array at its strongest point.
Next phase testing Halbach array 5:47 configuration for rotation.
Category
Science & Technology
Tuesday, February 26, 2019
(Exodus 20:1-6) "And God spake all these words, saying, {2} I am the LORD thy God, which have brought thee out of the land of Egypt, out of the house of bondage. {3} Thou shalt have no other gods before me. {4} Thou shalt not make unto thee any graven image, or any likeness of any thing that is in heaven above, or that is in the earth beneath, or that is in the water under the earth: {5} Thou shalt not bow down thyself to them, nor serve them: for I the LORD thy God am a jealous God, visiting the iniquity of the fathers upon the children unto the third and fourth generation of them that hate me; {6} And shewing mercy unto thousands of them that love me, and keep my commandments."
Sunday, February 24, 2019
Magnetic River: Professor Eric Laithwaite 1975
"And at that time shall Michael stand up, the great prince which standeth for the children of thy people: and there shall be a time of trouble, such as never was since there was a nation even to that same time: and at that time thy people shall be delivered, every one that shall be found written in the book. {2} And many of them that sleep in the dust of the earth shall awake, some to everlasting life, and some to shame and everlasting contempt. {3} And they that be wise shall shine as the brightness of the firmament; and they that turn many to righteousness as the stars for ever and ever. {4} But thou, O Daniel, shut up the words, and seal the book, even to the time of the end: many shall run to and fro, and knowledge shall be increased." (Daniel 12:1-4)
Saturday, February 23, 2019
High Profile Arrests & Human Trafficking - Program Opening Commentary - 2/22/19
But whoso shall offend one of these little ones which believe in me, it were better for him that a millstone were hanged about his neck, and that he were drowned in the depth of the sea."(Matthew 18:6)
Thursday, February 21, 2019
Tuesday, February 19, 2019
Monday, February 18, 2019
Friday, February 15, 2019
Thursday, February 14, 2019
Wednesday, February 13, 2019
Monday, February 11, 2019
Saturday, February 9, 2019
Friday, February 8, 2019
Thursday, February 7, 2019
If babies were born with guns, they could SHOOT post-birth abortionists in self-defense
Natural News) Do human beings have the right to defend themselves against violence?
Almost every thinking person agrees with the basic human right to self-defense. This right, upon further introspection, extends to all living human beings, regardless of age.
Post-birth abortion is a form of extreme medical violence that ends a human life, and with the Democrats now legalizing infanticide — the murder of a baby after it has been born alive — we need to talk honestly about the definitions of life, murder and self-defense.
Almost every thinking person agrees with the basic human right to self-defense. This right, upon further introspection, extends to all living human beings, regardless of age.
Post-birth abortion is a form of extreme medical violence that ends a human life, and with the Democrats now legalizing infanticide — the murder of a baby after it has been born alive — we need to talk honestly about the definitions of life, murder and self-defense.
As I point out in my podcast below, if babies were born with guns, they could SHOOT post-birth abortionists in self-defense. And those shootings would be justified and legal, since abortionists in the act are committing homicide against a living human being. Murder is illegal, and self-defense is a human right. Newborn babies are not excluded from this basic human right. Note that I am specifically not calling for any form of third-party violence against abortionists but rather affirming the right of the infant to protect her own life in an act of self-defense. (Yes, 50% of aborted babies are baby girls. Abortion is the mass murder of females.).....CLICK THIS LINK FOR THE REST OF THE STORY @ https://www.naturalnews.com/2019-02-06-if-babies-were-born-with-guns-they-could-shoot-abortionists-in-self-defense.html
Wednesday, February 6, 2019
Tuesday, February 5, 2019
Monday, February 4, 2019
Saturday, February 2, 2019
Friday, February 1, 2019
Subscribe to:
Posts (Atom)